Installations

TEEBAUD® is a multi-purpose non-skid underlay pad. It can be used on wall-to-wall carpeting or on smooth flooring surfaces. In order to obtain maximum satisfaction and the best results with TEEBAUD®, here are the installation procedures to be followed:

RUG on wall-to-wall carpeting:

Cut TEEBAUD® about 1"-3" smaller than the rug to be installed
Remove the plastic release liner
Place TEEBAUD®'s white side down, facing the wall-to-wall carpeting
Then place the rug on top of TEEBAUD®'s gray side.

RUG on smooth flooring surface:

Cut TEEBAUD® about 1"-3" smaller than the rug to be installed
Remove the plastic release liner
Place TEEBAUD®'s gray side down, facing the smooth floor
Then place the rug on top of TEEBAUD®'s white side.

CUTTING

TEEBAUD® can be easily cut with scissors or a utility knife.

FLOOR PREPARATION

Prior to installing TEEBAUD®, the floor should be vacuumed, clean and dry. Do not install TEEBAUD® on a wet floor. In order to obtain a long-lasting non-skid performance, avoid frequent removal and re-installation of TEEBAUD® from its designated installation area.

OVERSIZED RUGS

If several pieces of TEEBAUD® are necessary for one rug, simply apply as many pieces as needed, side-by-side. Taping or splicing is NOT necessary.

Before

After

Order Online Now